The purpose of this study was to build a database for point-bearing piles in dense noncohesive soil, predominantly moraine. Further, the database was analysed and areas with difficult geotechnical conditions was identified.The database includes for point-bearing piles driven to refusal in moraine. Piles with mainly shaft friction have been excluded. Only concrete piles have been included. Geographically the database covers almost all geotechnical conditions of Sweden.

Storage of biomass is associated with problems like heat development, biomasslosses, and reduction of the fuel quality. Certain processes such as biological- andchemical degradation are responsible for these storage problems. This master?sthesis was carried out at Vattenfall Research and Development AB and is alignedtowards quantifying the biomass losses from short-term storage (1-2 months) ofbark and recovered wood. The biomass was stored in outdoor piles during differentseasons, campaign 1 (summer) and campaign 2 (autumn).

When forces in foundation piles are calculated according to classic theory, thefoundation are assumed to be infinitely rigid which means that the foundation will notbend. High buildings need their whole width to be stable and use the ground floorwall as a foundation. But when, for example windows are needed in the ground floorwall, the stiffness of the foundation decreases which change the forces in the piles. Inthis report the difference of pile forces versus classic theory has been analyzed, and ifpile forces can be calculated as in classic theory. Further on, the effects of the wallmovement were analysed and how the buildings crack safety would be affected by themovement at the ground floor.

Piled friction soil show a set-up which is increasing with the time after installation. The cost could be reduced if the set-up had been taken into account when designing but in Sweden it is very unusual to do that. Previous studies showed that set-up can vary between 25 % and 75 % during the first 90 days after pile installation. This showed that the effect of the phenomenon is difficult to predict. A study involving five projects have been carried out by specifying certain parameters like pile type, method for pile installation and test method for measure the bearing capacity in friction soils located in Sweden.

Energy is today a very common topic, not only in Sweden but in the whole Europe. In EU they have given out a directive 2002/91/EG about buildings energy use and throw this they have forced their members to show how much energy their buildings use. In Sweden has the gouvernment established a law (SFS 2006:985) about energy declaration for buildings which demands that the building owner needs to show how much their buildings energy consumption are. Important to know is that this law doesn´t applies for industrial buildings.The report will show what the new law about energy declaration for buildings and appurtenant directions will mean for Riksbyggen. Also energy calculations will be done to be able to compare Riksbyggen buildings with the new law and directions.

Storage of biomass is often associated with problems such as heat development, dry matter losses and reduction of fuel quality. The rise in temperature can potentially cause a risk of self-ignition in the fuel storage. Moreover, emissions from storage piles can cause health problems in the surrounding. The dry matter losses and reduction of fuel quality can have economical effects. The aim of this thesis project is to develop guidelines on how to store large amount of biomass at Vattenfalls heat and power plants in an optimal way.

Increased energy consumption in the world has created an increased supply of various fuels, especially fossil fuels. The Swedish government has set up various energy targets for 2020. To reach these goals it?s important to increase the energy efficiency in local buildings such as schools. This work illustrates the breakdown between energy supply and energy losses over the school.

The purpose with this report is to examine how the implemented energy efficiency measures on Bokelundskolan in Växjö have had impact on the energy use. The measures which have been implemented are, new ventilation system, new heating system, optimized adjustment of the heating system, new windows with U-value 1.2 and lower window height, insulation under windows and in the crawl space. The school's energy use before and after rebuilding has been calculated with the calculation program, Vip-Energy 1.5.5.Calculations of energy use for the school with windows on U-value, 0.9 and 0.7 have also been done. The replacement of windows has been studied from a cost perspective. The conclusion is that the exchange of heat and ventilation system was the biggest contributor to reduced energy use on Bokelundskolan.

In today?s society there is an increasing demand for renewable energy sources such as sun and wind power. These sources are intermittent, and energy storage is therefore needed to ensure a constant power supply. This report compares pumped hydro energy storage (PHES), compressed air energy storage (CAES), flywheels, batteries, super magnetic energy storage (SMES) and hydrogen energy storage.The opportunities for further development are limited for PHES and CAES in comparison with the other technologies. Lithium-ion batteries and hydrogen energy storage are considered to have the most potential in the future.

Energy awareness is growing among the Swedish population and a one­?to­?two-family dwelling can save energy. The purpose of this paper is to design a tool that helps these home owners reduce their energy costs.The paper develops a model that gives them an indication of how much energy they can save. For the majority of homeowners, the next step in the quest to reduce theirs is most likely an energy audit. Therefore, information to help home owners to get a good energy audit performed is included in the model.A prototype running the operating system iOS is created and validated against existing models, as well as an energy audit. .

Lyckeby Starch AB is a farmer-owned company that produces products based on potato starch. In order to increase their production efficiency and their international competitiveness the company is investigating the possibilities of keeping their factories open longer. To achieve this, potato has to be stored for a longer period of time than what is practiced today. Starch potato is usually stored in large piles covered by straw and plastic, either in the field or on the farmyard. The objective was to examine in what way starch yield (starch content*tuber weight) in three different potato varieties was affected by storage in two different types of storage piles. The potato was stored for three months in total and starch content and tuber weight were controlled throughout the period. Stored tubers were also visually examined and prescense of mechanical damage as well as wet rots and dry rots was recorded. Bacteria and fungi were isolated and identified. In general, varietal differences were greater than differences between the storage piles.

To build a sustainable future should we first understand that; every aspect of our daily lives can affect the environment. It?s important that we take responsibility for understanding how we impact the environment and change our actions accordingly. The worlds total energy consumption equivalent to 80 million MWh / year. This corresponds to about 220 million MWh / day.Energy consumption is one of the main reasons for increased greenhouse gases when the reduction of this consumption has a great demand worldwide.In order to prevent the energy that consumed the buildings must be energy efficient but there is a conflict between radon ventilation and energy conservation in a building, given that ventilation can consume as much energy (currently 29-59% of energy-efficient houses use), especially in a cold climate as in Norway.

The purpose of this study was to implement an energy analysis and environmental evaluation of the property Hemsta 12:16 in Gävle. Based on two different methods, Energy Balance calculation and Environmental Building, the result of the property's energy use, energy performance and environmental impacts are presented. Except that, measures to reduce final energy consumption are presented.      The proposed measures can reduce energy usage by 100 400 kWh / year, which represents a decrease of 18% of the present energy usage. This would represent a total savings of 63 000 SEK per year. In addition, the environmental performance is improved by adopting the suggested measures..

The question of excessive global energy use needs to be solved. All energy production and usage have negative environmental impacts, which are best solved by reducing energy consumption and by using energy more efficiently. A large part of the Swedish energy use is concentrated to the building sector and to reduce the total energy consumption real efforts need to be made to make buildings more energy efficient.The aim of this study was to investigate how energy is used in one of Göteborg University?s buildings and to find measures that can be taken to improve its energy efficiency. The chosen building Zoologen, is used for research and education.The main method of the study is computer simulations of the present building and of possible energy reducing measures to be made in the future.

Piles of deadwood are often retained in forests after management to support the biodiversity ofsaproxylic organisms which depend on deadwood to survive. Any knowledge about the crucial role ofpiles as suitable habitat of saproxylic organisms compared to single distributed deadwood objects thatare around the piles would help conservation actors to motivate more forest owners to supportsaproxylic organisms during their management. Therefore to give facts to this the saproxylic fauna ofdifferent pile positions (up and low) was studied and compared to distributed deadwood samplesaround each pile. Our study was focused on saproxylic beetles. Some other parameters such asdiameter, deadwood volume, pile volume and decay stage were assessed to define any effect.